Rms-technologies IMC17 INTEGRATED MOTOR CONTROLLER/DRIVER Manuel d'utilisateur télécharger pdf (Page 15)

Changing the Address of the Controller

Use a screwdriver to turn the dial so the arrow points to the desired Address. Use

this number when programming commands. For example, /1P1000R

Figure 8: Address Dial

Note: New RoHS compliant boards have a Black dial instead of a Red one.

Connecting Accessories

If you have purchased the Designer’s Kit, there is a Red Push Button and an Optical

Sensor included. Follow the schematics below in order to properly assemble

accessory pieces.

Push Button

Figure 9: Push Button Schematic

It is best to solder the Push Button to Pin 5 which corresponds to Input 4, then

solder Pin 6 (Power Ground) to the other side of the push button.

Input 1 Pin 2

Input 2 Pin 8

Input 3 Pin 7

Input 4 Pin 5

Table 7

RMS Technologies Page 15 4/3/2009

IMC17/IMCE17 User Manual Rev 1.06

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 21 22 23

Pas de commentaire

Rms-technologies IMC17 INTEGRATED MOTOR CONTROLLER/DRIVER Manuel d'utilisateur Page 15