Rms-technologies IMCE23 INTERGRATED MOTOR+CONTROLLER +DRIVER+ENCOD Manuel d'utilisateur télécharger pdf (Page 13)

R356 Controller & Driver Page 13 Version 1.06

RMS Technologies 2/17/2010

7. CONFIGURING AND CONTROLLING THE R356

HyperTerminal Setup

Please follow these steps in order to properly set up HyperTerminal:

1. Open a terminal from your PC by following these steps: Start Menu Æ Programs Æ

Accessories Æ Communications Æ HyperTerminal

2. Assign a name for your New

Connection

3. Determine the correct COM port # by

right clicking on “My Computer” and

selecting “Properties”. Select the

“Hardware Tab” and click on “Device

Manager”.

Note: if you are using the USB485

converter card, first download driver files

(found online: www.rmsmotion.com

You should then see the RMS USB 485

converter card in the “Ports (COM & LPT)”

area.

If you are connecting via RS232, most

likely it is COM1, “Communications Port”.

4. Under ‘Connect using’, select the COM

connection that corresponds to your PC serial

port (i.e. COM 1, COM 2, etc.) then click ‘OK’

5. Set your Port Settings to default (i.e. 9600

baud, 8 data, no parity, 1 stop bit, no flow

control)

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 22 23

Pas de commentaire

Rms-technologies IMCE23 INTERGRATED MOTOR+CONTROLLER +DRIVER+ENCOD Manuel d'utilisateur Page 13